Hydrophobic Urethane Grout (Communities - Garage Sales)

USNetAds > Communities > Garage Sales > Hydrophobic Urethane Grout

Item ID 129162376 in Category: Communities - Garage Sales

Hydrophobic Urethane Grout


Product introduction:LW Hydrophobic polyurethane chemical grout is a kind of one component and excluding water material,Website:http://www.lwconchem.com, which is formed via polyisocyanates and polyether polyol reacted under certain conditions. When grouting, NCO perssad meet water, the reaction of chain extension, branching, cross linking and solidification are produced, therefore, stop water rapidly and reinforce concrete effectively. Meanwhile heavy expansion pressure is generated so that to make the grout diffused again. Accordingly, push the grout forward to permeate crack and hole deeply. So it has enough scope of diffusion and solidification.Characteristic:●Rapid reaction, foaming, solidification are generatedafter meeting water. adjusting gel time by adding catalyst. The gel time is usually controlled within 10 seconds● High strength. Under hermetic condition, the compressive strength can be 17-20Mpa in 4 hours.25-30MPa compressive strength and 3MPa bonding strength can be reached in 24 hours.● Big expansion ratio. Since foaming, the expansion ratio can be 20 twice.●The grout  is single component with convenient operation.● Steady indurate chemical construction. Good property of bearing chemical resistance.●No corrosion to steel.Item IndexApplication:It is mainly applied to treatment of basic seepage-proofing in concrete expansion joint, crack, construction joint of water conservation water and electricity, tunnel, subway, civil defence, metallurgical engineering, industrial and civil architecture ect.Processing 1. Check the part of leaking, reason and direction. 2. Drill the hole near the part of leaking. The slant hole can be drilled through the crack if the crack is deep. The width of two holes is different according to the width of crack. Normally it is 20-50cm.The crack is more narrow, the width is smaller. When crack wider and width wider. 3. Burying injection hose via rapidly sealing hole device or rapid hardening material. Meanwhile seal surface of crack. 4. Swashing the crack via pressured water or air. Checking the stringing case between holes and effect of sealing 5. Grouting, connecting the injection pump and hose to begin grouting. The pressure of grouting depends on the size of crack, quantity of grout absorb and detailed case of project. Order of grouting is from bottom to top, from depth to shallow. Pausing to grout then tie the hose when the pure grouting appears at neighboring holes. Put the grout to neighboring hole to continue grouting. Under specified pressure until reach the standard of finished grouting. The grouting doesn’t solidify without meeting water. So after grouting, 20ml water need to be injected via another injection pump to make the material solidifying, avoiding to leave material when discharge hose. 6. Removing the injection hose after solidifying and trim the surface of crack. The material of trimming can be rapid inorganic material, dedicated epoxy mortar sealing material or flexible polyurethane sealant that are supplied by supplier. 7. Clean all tools via solvent after finishing grouting.Store:5-30℃ based on original package, dry place. Shelf life:6 months.Package200kg or 25kg in a iron drum


Related Link: Click here to visit item owner's website (0 hit)

Target State: All States
Target City : All Cities
Last Update : Oct 08, 2016
Number of Views: 120
Item  Owner  : BEIJING LANGWEI TIMES TECHNOLOGY AND SCIENCE CO.,LTD
Contact Email:
Contact Phone: 86-10-67081601

Friendly reminder: Click here to read some tips.
USNetAds > Communities > Garage Sales > Hydrophobic Urethane Grout
 © 2017 USNetAds.com
2017-09-21 (0.083 sec)